Filament Heater FH15 and FH21
The wide open frame is the most important technical characteristic of this machine. The width of the machine allows you to work on several pieces at any one time or one piece up to the width of the machine (1550mm or 2100mm). The second characteristic is the water- cooled lines help in reducing the “banana” effect to a minimum. The machine is automatically started and opened by a Timer.
The machine can be constructed with, either, two, three or four lines. Each line has a top and bottom section and each line is fully adjustable.The machine needs a power supply of 400 Volts / 16Amp or 20Amp. the Lines are working with 24 or 48 Volts. The tension of the heating wires is automatically adjusted and the hight of the Wire is adjustable. The timer allows you to adjust the time, as you want.
The machine is very simple to adjusted and operate. The only extra thing required is a water container with a minimum of 200 or higher litres. This can be purchased at any D.I Y. store for a very modest outlay.
Biegemaschine FH15 oder FH
Working Width: 2100 mm oder 1550 mm
Total Width: 2500 mm
Working depth: 1000 mm
Total depth: 1500 mm
Working hight: 900 mm
Total hight open position: 1650 mm
Minimal distance for the Heating lines: 50 mm depending on the gap size
Adjustable Material Stop incl.
Heating Lines by Order: 1 up to 4 pcs. for FH21 and max. 1 up to 2 Lines by FH15
Time adjustment: 0 - 600 h einstellbar in Sec., Min. or hours.
Air Pressure needed: min. 7,5 Bar
Water Connection In and Out. Excl. Watertank und Pump
Power for Waterpump on the Electric Box: 220 Volt/16 Amp.
Power Supply needed: Bis FH15, FH21-1 + FH21-2 400Volt/16Amp., FH21-3 + FH21-4 400Volt/20Amp.
Power on Heating Wire: FH15 24 Volt, FH21 48Volt
- Extra Stop
- Extension Arms for larger Parts
This machine will be special produced in Order by the customer.